Shu's weekly group discussion

Asia/Shanghai
Tsung-Dao Lee Institute/N6F-N630 - Smart Classroom (Tsung-Dao Lee Institute)

Tsung-Dao Lee Institute/N6F-N630 - Smart Classroom

Tsung-Dao Lee Institute

Also at Room 603, New Science Building #5, Minhang Campus
15
Haidar Mas'ud Alfanda (TDLI, SJTU), Matthias Tartarin (TDLI, SJTU)
Description

Online Zoom meeting room:

https://cern.zoom.us/j/4042031778

(PIN protected, see message from the group chat announcement)

    • 10:00 10:05
      Introduction & Announcements
    • 10:05 10:10
      Status 5m
      Speaker: Zhijing Zhang (TDLI, SJTU)

      Today's focus: 

      [STCF]:

      • Muons were simulated to incident laterally on the CsI crystal, to obtain the relationship between the crystal’s light output and the particle‑interaction position. (differences exist between simulation plots and experimental data, and this issue remains unresolved)

      [DarkSHINE]:

      • Carried out a test in a thermostat chamber to study the gain of single‑photon response under different temperatures and bias voltages. Data acquisition has been completed, while data analysis is yet to be carried out.
      • Studied several literatures on collider calorimeters.

      Plans: 

       

      [STCF]:

      • Analyze the differences between simulation configuration and experimental setup, and modify the optical parameters in the simulation so that the trend of simulated data curves agrees better with experimental results.

      [DarkSHINE]:

      • Analyze the data collected last week, and obtain the single‑photon gain via multi‑Gaussian fitting.
    • 10:10 10:20
      Status 10m
      Speaker: Kang Yu (TDLI, SJTU)
    • 10:20 10:30
      Status 10m
      Speaker: Linjing Duan (TDLI, SJTU)

      [ZZy]

      FInished

      • Migrated the Run-2 ZZγ JO to the Sherpa 3 YAML format with AthGeneration 23.6.60.
      • Successfully completed the 13 TeV initial generation test and produced a valid EVNT file.
      • Checked the Run-2 PRW and cross-section handling in EasyJet
      • set up the initial EasyJet ZZγ structure and completed a small Run-2 test run

      Plan

      • Finalize the JO settings and perform higher-statistics tests at 13 and 13.6 TeV.
      • Prepare the gridpack and validation materials, then create the JIRA ticket for the MC sample request
    • 10:30 10:40
      Status 10m
      Speaker: Jun Wei Lok (TDLI, SJTU)

      Troubleshooting Static Quiescent Current Discrepancies using TINA-TI

      Measured static quiescent current  exhibited noticeable deviations from expected values. To isolate the root cause, I constructed a high-fidelity circuit model in TINA-TI to mirror the real-world test environment


      Thermal Benchmarking & Verification via Ansys Icepak
      Standardized Electronics Cooling Modeling: Built detailed Compact Thermal Models (CTM) in Ansys Icepak to serve as the benchmark for existing COMSOL simulations



       

    • 10:40 10:50
      Status 10m
      Speaker: Zelin Yan (TDLI, SJTU)

      [Today's focus:]

      • Wlllv analysis: 
        • Most exp. and theory uncertainties are implemented in preliminary SR+WZCR fit 
        • mlll and mT_lllv both shows similar expected sensitivity with total uncertainty of ~11% on mu_sig. 
        • WZ norm is constrained to ~3%. 
      • H2a4b analysis: 
        • Generate baseline cut ntuples with mc23ade and data22 23 24. 

      [Next Plans:]

      • Wlllv analysis: 
        • DNN model shows better data/mc agreement in SRsideband, will cross check in xgboost. 
        • Finish BDT section in INT note. 
      • H2a4b analysis: 
        • Generate Z+jets CR and SR ntuples and get preliminary expected upper limit.
        • Data/MC in Z+jets CR. 
    • 10:50 11:00
      Status 10m
      Speaker: Bai-Hong Zhou (TDLI, SJTU)

      [Hyy*]:

      • Updated the plots in our paper draft based on the comments;

      [ssWW]:

      • Presented our systematics study and preliminary significance results in the weekly meeting;

      Plans: 

       

      [ssWW]:

      • Prepare to launch new sample production once the sherpa3 samples are ready;
      • Try some stratogies to improve the ParT performance;

      [DarkSHINE FastSimu]:

      • Wait for the training results using the new samples with larger statistics (~5M enents);
      • Evaluate the training results

      [HWW QE]:

      • Learn the Hypothesis test strategy in HZZ QE;
      • Train the EveNet with the new input samples;
    • 11:00 11:10
      Status 10m
      Speaker: Xuliang Zhu (TDLI, SJTU)
    • 11:10 11:20
      Status 10m
      Speaker: Zhiyu Zhao (TDLI, SJTU)
    • 11:20 11:30
      Status 10m
      Speaker: Haidar Mas'ud Alfanda (TDLI, SJTU)

      Exotic Higgs decay analysis

      • The training features from the XCone algorithm are found to be compatible with those from the ee-kT algorithm – we therefore expect the similar tagging efficiency.
      • An example of jet kinematics is shown below. Left to right: Jet energy constituents, difference in azimuthal angle between the particle and the jet axis, difference in pseudorapidity between the particle and the jet axis.

         
      • Training the ParT model on the IHEP cluster using GPU resources is slower than expected, possibly due to a high queue of jobs. If this problem persists, we will need to consider an alternative solution.
    • 11:30 11:40
      Status 10m
      Speaker: Matthias Tartarin (TDLI, SJTU)
    • 11:40 12:35
      REU: Undergraduate Research Discussions
      • 11:40
        Status (w/ Linjing&Danning) 10m
        Speakers: Bingxian Li (SPA, SJTU), Jiacheng Shi (SPA, SJTU), Yuning Chen (Zhiyuan College, SJTU), Zhengyang Qian (SPA, SJTU)
      • 11:50
        Status (w/ Haydar) 10m
        Speakers: Hansheng Ye (Univ. of Manchester (GB)), Mingyu Huang (Univ. of Manchester (GB))
      • 12:00
        Status (w/ Matthias&Baihong&Xuliang) 10m
        Speaker: Ardijan Lorant Ferati (Eberhard Karls University of Tübingen (DE))
      • 12:10
        Status (w/ Xuliang) 10m
        Speaker: Hongyi Chen (University of Nottingham, Ningbo, China)